New Hampshire company serves customers by offering efficient project management of both millwork and cabinets.
Optimism in the retail market leads to large-scale expansion for store fixture and millwork producer.
Longtime Milwaukee millwork producer does major medical projects, upscale restaurants to offset slower markets.
More content about Architectural MillworkCNC router manufacturer Thermwood set up a furniture-making operation in its own plant to test its cell manufacturing techniques.
Realizing the dream of being able to economically build custom furniture on a mass scale.
This year's NeoCon was an affirming experience.
More content about Furniture DesignQ: We wanted the strongest joint possible so we used epoxy, but the joints are failing. Any comments?
Q: We have some cypress 4/4 lumber that the customer returned as being unsatisfactory after he has already put it into use. The surface is corrugated and very bumpy, but I know that it left here smooth as a pancake. Can you tell me what has happened? Also, in a few places, the grain where the grain is very flat has separated and you can lift up long slivers with your fingernail.
Q: I am in a tropical island and am sending you several
large sized table legs. You will notice that there are some
substantial splits, which seem to, more often and not, be at the
ends. We see these after we unload the furniture from the
container and put it in our warehouse here near the coast.
Sometimes, the splits are delayed until the pieces reach our
sales area. What is going on? Everyone is pointing
fingers.
More content about Furniture ComponentsQ: We are using southern yellow pine for furniture and
have been getting what looks like lengthwise shrinkage. However,
I was always taught that wood does not shrink along the grain.
Can you help please?
Learn the desirable and not-so-desirable special
properties of some woods
A variety of wood glues are used to assemble the 175 pieces in a six-string guitar. Matching the proper adhesive with the application is important for Taylor Guitars.
More content about WoodworkingQ:I have recently noticed that our incoming lumber is
about 4 percent MC. Our kiln operator says it is higher and that
he could not dry the wood that dry. What do you think?
Proper heat treatment is as important as the selection of HSS for tooling.
Getting the most from a widebelt sander and abrasives is a matter of balancing your budget with proper features to perform the work needed.
More content about Wood Production